Adaptec 5325302057 User Manual page 157

Continue adding user names and passwords until all users are included on the
4
list.
The user list must have at least one name on it.
Note
Click to close the window.
Cancel
5
Repeat Step 2 to 5 for each logical device with CHAP authentication.
6
Click , then click
Next
7
Click , then click
Apply
8
Removing iSCSI Targets and Adding the Appliance IP Address
On the iSCSI Storage Host, go to the
1
.
Initiator
The iSCSI Initiator Properties window opens.
Click the tab, then log off any iSCSI target whose status is 'Reconnecting'.
Targets
2
Click the
Persistent Targets
3
'Inactive'.
Click the
Discovery
4
From the list of IP addresses, remove any address that does not belong to the
5
iSCSI Storage Appliance.
Click .
Add
6
Enter the IP address for the iSCSI data port on your iSCSI Storage Appliance (as
7
set in "Step 2: Configuring the iSCSI Storage Appliance" on page 36), then click
.
OK
If your iSCSI Storage Appliance has two iSCSI data ports, repeat this step for the
other port.
Logging into the iSCSI Targets
In the iSCSI Initiator Properties program, click the
1
Select an iSCSI target, then click
2
Select
Automatically restore this connection...
3
If CHAP is enabled on this iSCSI target, click
, enter the user name and password ('target secret') for that iSCSI
information
target, then click
OK
The target secret is the password you set in "Removing iSCSI Targets and
Note
Adding the Appliance IP Address" on page 151.
Click to log on to the iSCSI target.
OK
4
Recovering from an iSCSI Storage Appliance Failure
again.
Next
.
Yes
Start
tab, then remove any iSCSI target whose status is
tab.
Log On...
.
menu and open
Microsoft iSCSI
tab.
Targets
.
.
, select
Advanced
Chapter 12 Solving Problems
CHAP logon
151