Adaptec 5325302057 User Manual page 176

iSCSI Configuration for Red Hat or SUSE Linux
If you want to use one-way CHAP for the logical devices on your iSCSI Storage
b
Appliance, provide Username and Password values below the
DiscoveryAddress parameter.
• To indicate that the CHAP parameters are only associated with iSCSI targets
behind the portal, leave at least one leading space before the
Password=
DiscoveryAddress=192.3.2.187
Username=a
Password=111111111111
• To indicate that the CHAP parameters are global, leave no leading spaces
before the
the iscsi.conf file.
Start the initiator by entering this command:
7
linux:~ #: /etc/init.d/iscsi start
You'll see this message:
Starting iSCSI: iscsi iscsid fsck/mount
If you open a new window and enter this command, you can watch the
Note
syslog messages as you start the initiator:
linux:~ #: tail -f /var/log/messages
You may see errors and warnings during the startup.
The initiator should have discovered and logged onto the targets. Use
8
see which targets you are connected to.
You can also use
Note
disks.
linux:~ #: iscsi-ls
You will see output similar to the following:
******************************************************************
Cisco iSCSI Driver Version ... 4.0.188.26 ( 21-May-2004 )
******************************************************************
TARGET NAME
TARGET ALIAS
HOST NO
BUS NO
TARGET ID
TARGET ADDRESS
170 Snap Server 700i Series User's Guide
lines, as shown in this example.
and
Username= Password=
cat /proc/scsi/scsi/
: iqn.snap710622.iscsi0
: iscsi0
: 1
: 0
: 46
: 192.3.2.187:3260
lines and put them in the beginning of
to view iSCSI targets as regular SCSI
and
Username=
to
iscsi-ls