Adaptec 5325302057 User Manual page 162

Configuring iSNS with the CLI
Log in to the CLI as Administrator, using the password you set in "Step 2:
3
Configuring the iSCSI Storage Appliance" on page 36. If you didn't set a
password, use the default password,
Enter:
4
isns
Enter:
5
server IP_address
Where
IP_address
To exit the CLI, enter:
6
end
quit
For more information about the CLI, see "Using the CLI" on page 177.
Note
Configure iSNS in the iSCSI initiator.
7
You will need to configure the initiator and add an iSNS server to complete the
configuration of iSNS.
For example, from a Windows client:
• When using the Microsoft initiator, run the Microsoft initiator software, select
the iSNS Servers tab, and click
server, and then click
• When using the QLogic4050/4052 initiator, right-click the QLogic adapter and
select
Properties
Discovery
click
OK
After you have completed this procedure, all the iSCSI targets on the iSCSI
Note
Storage Appliance automatically appear in the Microsoft Initiators target list.
156 Snap Server 700i Series User's Guide
is the address of the iSNS server (see Step 1).
.
OK
. Select the Discovery Configuration tab, and check
. Check
Use iSNS Server
.
.
admin
. Enter the name or address of the iSNS
Add
, enter the server name or IP Address, and
Perform