Adaptec 5325302057 User Manual page 170

iSCSI Configuration for Microsoft Windows
Configuring the QLogic QLA4050 and QLA4052 iSCSI Initiators for
Microsoft Windows
Requirements
• Windows 2003, Windows 2000, Windows XP installed server.
• Microsoft iSCSI Software Initiator
Installing the Adapter
Install the QLA4050/4052 adapter on a system running Windows 2003 or
1
Windows 2000 Server or Windows XP Professional SP3.
Boot up the system and follow the Windows
2
the associated driver software.
Install SANSurfer, which came with the adapter.
3
Configuring the QLA4050/QLA4052 iSCSI Initiator
QLogic's QLA4050/4052 is an iSCSI adapter that appears as a SCSI adapter instead
of a network adapter in Windows Device Manager. Before it can successfully
connect to iSCSI targets, you must:
• Set initiator parameters (for example, initiator name, alias, IP address).
• Enter target information (for example, target portal information and target iSCSI
name).
• Configure the adapter's BIOS. Refer to article 14837 on the Adaptec Support
Knowledgebase at www.adaptec.com.
You can use either the SANSurfer Management application that came with the
QLA4050/4052 or Microsoft's iSCSI initiator applet to set initiator parameters and
enter target information.
164 Snap Server 700i Series User's Guide
Found New Hardware
dialog to load