Adaptec 5325302057 User Manual page 108

Configuring the Uninterruptible Power Supply (UPS) Monitor
Select a UPS connection type.
3
• If you select
SNMP Name field.
• If you select
In the Add Remote USB Enclosure window, enter the name or IP address of a
remote iSCSI Storage Appliance to which the local system will communicate
UPS information, then click
Repeat this step until you have added all the iSCSI Storage Appliances you
want to communicate with the local USB connection.
To remove an iSCSI Storage Appliance from the list, select it, then click
Note
Remove
• If you select
the USB Connected Enclosure field.
In the Enclosure Powered Off box, set the battery life threshold at which the iSCSI
4
Storage Appliance powers itself down. (The default is two minutes.)
Click .
OK
5
Repeat the steps in this section for each iSCSI Storage Appliance in your IP SAN.
102 Snap Server 700i Series User's Guide
, enter the SNMP host name or TCP/IP address in the UPS
SNMP
, click
Local USB
Add
.
, enter the local USB host name or TCP/IP address in
Remote USB
.
Add
.