Step 4: Configure Your Server Using The Initial Setup Wizard - Adaptec Snap Server 110 User Manual

If using a DHCP server (server that automatically assigns IP addresses), skip to
3
the next step. Otherwise:
In the SSM console, right-click a server name and select
need to have the following information:
• The IP address for the Snap Server (required)
• The subnet mask (required)
• The default gateway IP address
• The domain server IP address
• WINS server(s) IP address(es)
At a minimum, enter an IP address for the Snap Server and a subnet mask, and
then click
OK
Launch the
4
Administration Tool
from the SSM console.
In the SSM console,
right-click a server
name and select
Web Administration
Log into the
5
Administration Tool.
Click the
Administration
link, and in the login
dialog box, enter admin
as the user name and
admin as the password, then click
Complete the Initial Setup Wizard.
6
For instructions on using the Initial Setup Wizard, see the next section.
Step 4: Configure your Server Using the Initial Setup
Wizard
The first time you connect to a Snap Server using the browser-based Administration
Tool, the Initial Setup Wizard runs. The Initial Setup Wizard consists of several
screens that allow you to change the server name, set the date and time, set the
administrator password, configure TCP/IP settings for the Ethernet port
(Ethernet1), and reclaim storage space that has been reserved in case you want to
use Snapshots.

Step 4: Configure your Server Using the Initial Setup Wizard

.
Launch
.
OK
Set IP Address
.
Chapter 1 Installing the Snap Server
. You will
11