Table of Contents
Advertisement
System components and expansions
8.7.1
Installing/removing power supply or dummy unit
Figure 41: Remove power supply unit
Ê Disconnect the power cable from the power supply unit (1).
Ê Slide the latch on the power supply/dummy unit in the direction indicated by
the arrow (2), and pull the power supply/dummy unit out of the installation
slot (3).
Installing is done in the reverse order.
V
CAUTION!
Please make sure that during installation the power supply unit clicks
correctly into position and engages in the installation bay. This prevents
the power supply unit from sliding out at the fixture and becoming
damaged.
U41147-J-Z156-2-76
Power supply units
87
Advertisement
Table of Contents
