Table of Contents
Advertisement
Hot-pluggable hard disk drives
8.2.2
Installing/Removing HDD/Dummy Unit
Removing the dummy unit
Free slots are provided with a dummy unit (an empty carrier) which must be
removed before installing an additional HDD module.
Figure 30: Removing the dummy unit
Ê Press the upper and lower tabs on the dummy unit together (see Figure
on page
90) until the locking mechanism disengages, and remove the
dummy unit from the slot.
To install a dummy unit, follow the same procedure in reverse order.
V
CAUTION!
Keep the dummy unit for future use. If the HDD module is removed again
and not replaced with a new module, then the dummy unit must be
reinstalled due to cooling, the applicable EMC (electromagnetic compat-
ibility) regulations and fire protection.
90
Operating Manual
Hot plug components
TX150 S5
30
Advertisement
Table of Contents
