Table of Contents
Advertisement
LinMot
5.10 Error Inspector
5.10.1 Operational elements of the Error Inspectors
Error display
Error list
User Manual V1.01
With the Error Inspector the user of the LinMot
about warnings and errors occurred during operation. The Error Inspector offers the
possibility to inspect the actual errors and pending warnings as well as the last 16 errors
and warnings that were logged in the LinMot
The following figure shows the Error Inspector window:
Error list
Error display
Figure 5-17: Interface of the Error Inspector
The following sections describe the groups indicated in the Figure above:
The error messages contain information about system time, state of the basis software,
drive type and type of error. The time is given in the "HHHH:MM:SS" format, where
"HHHH" is the number of hours, "MM" the number of minutes and "SS" the number of
seconds.
These buttons control the access to the errors stored in the electronic unit.
Show: The "Show" command reads the last 16 error entries from the LinMot
unit and displays them in the error display. Note that not all the errors that lead to the
"Error" state are saved and viceversa. The errors that should be logged are specified in
the parameter tree under the System\Error Handling\Logging mask.
Clear: This command deletes the entire list from the LinMot
confirmation is asked before executing this command.
Configuration Software
®
electronic unit can obtain information
®
electronic unit.
Actual errors
Actual warnings
5-22
®
electronic
®
electronic unit. A
Advertisement
Table of Contents
