Table of Contents
Advertisement
LinMot
Signal supply
Power supply
User Manual V1.01
Caution: Before putting into operation, the housing of the electronic unit must be
grounded. The grounds of the signal and power supplies must also be connected to earth
at some point.
Table 4-7: Signal supply pin connection for the E1000/E2000/E4000
Data:
Input voltage:
Input current:
The linear motors reach their maximal force and full dynamics only when supplied with
a 72V DC power supply (see data sheets of the linear motors).
Table 4-8: Power supply pin configuration E1000/E2000/E4000
Data:
Input voltage:
The required power strongly depends on the loading of the motors. For an optimal
design of the power supplies the power requirements of each application should be
clarified individually.
Practical applications have shown that in most cases, even when driving four linear
motors LinMot
P at the same time with one E4000 electronic unit a power supply of
72V/600W is sufficient.
Pin
Signal
top
+Vcc Power Supply Logic
middle
GND
bottom
do not connect !
24 - 48V DC
400 mA (at 24 V)
Pin
Signal
top
GND
bottom
+Vcc Power supply
48 - 72V DC
4-22
Design and Installation
Advertisement
Table of Contents
