Commander; Control Panel - LinMot Step User Manual

   
LinMot

5.5 Commander

5.6 Control Panel

"Start"
"Stop"
"Reset"
"Load"
User Manual V1.01
The Commander is the central control panel of the LinMot
modules for the configuration and commissioning of the LinMot
called from within it.
With the control panel the user can start or stop the software on the LinMot
unit. In case of a fatal system error there is also the possibility to reset the unit. When
updating the basis software, the new software can be downloaded to the electronic unit
with the "Load" command.
Starts the operating software of the LinMot
Stops the operating software of the LinMot
Executes a hardware reset on the LinMot
fatal system error has occurred. A fatal error is signalized on the front panel of the
®
LinMot electronic unit by the blinking of the "Fault" LED, and should never occur
during normal operation.
Loads a new basis software in the LinMot
Configuration Software
Figure 5-3: Commander window
Figure 5-4: Control Panel window
®
electronic unit, if it is not already running.
®
electronic unit. All motors are turned off.
®
electronic unit. This is only necessary if a
®
electronic unit.
5-4
®
Talk software. The single
®
electronic unit can be
®
electronic