Table of Contents
Advertisement
LinMot
4.9 Mechanical installation
User Manual V1.01
The fixing of the electronic units is done by means of two M5 screws. The electronic
unit can be screwed on to any backplane. The special fixing holes allow for easy
mounting and removing of the unit.
The electronic units LinMot
and should be mounted in vertical position to allow better cooling. When mounting the
units it is important to take into consideration the fact that the housing temperature can
reach 60° (heatsink up to 70°). Sufficient room for heat dissipation should be provided.
The power dissipation of the units can vary considerably depending on the application
and should be determined for each case. An internal protection mechanism shuts the unit
down when over temperature of the heatsink is detected.
Design and Installation
®
®
E400-AT and LinMot
4-25
E200-AT are fitted with a heatsink
Advertisement
Table of Contents
