Curve Inspector; User Interface Of The Curve Inspector; Operational Elements Of The Curve Inspector - LinMot Step User Manual

   
LinMot

5.8 Curve Inspector

5.8.1 User interface of the Curve Inspector

5.8.2 Operational elements of the Curve Inspector

Curve window
User Manual V1.01
With the Curve Inspector the user disposes of a simple way to generate and modify
reference curves for the different drive types. Curves can be loaded from files or from
the electronic unit, edited and combined, and finally saved to a file or to the electronic
unit.
This chapter is divided in two parts: the actual Curve Inspector and the Curve Editor.
The interface of the Curve Inspector appears after clicking on the "Curve" button in the
Commander window. Figure 5-8 shows a typical Curve Inspector window.
Curve window
Edit buttons
Figure 5-8: User interface of the Curve Inspector
The single operational elements are described in the following chapter.
All curves that are loaded or newly generated are listed in this window. New entries are
appended at the end of the list. The name, motor type (Drive Type), number of points
(Samples) and time (Time) in which the curve is run are displayed. The number is only
valid in this window and is used to distinguish missing or equal curves.
Configuration Software
Scroll buttons
Status window
5-10
Memory window
Memory buttons