8-1-4: Ifx1 - Korg M3 Parameter Manual

AUX/Ctrl:
AUX (AUX Bus)
Ctrl (FX Control Bus)
Send1/2:
Send1
Send2
For more information, please see "8–2: Insert FX Setup" on
page 99.
▼8–1–3: Menu Command
• 0: Write Combination ☞p.185
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy Insert Effect ☞p.117
• 4: Swap Insert Effect ☞p.118
For more information, please see "Combination: Menu
Command" on page 185.
[Off, 1, 2, 3, 4, 1/2, 3/4]
[Off, 1, 2]
[000...127]
[000...127]
COMBI P8–1: IFX 8–1–4: IFX1
8–1–4: IFX1
8–1
–4a
This page lets you edit the detailed parameters of the five
insert effects. Use the tabs at left to select IFX1 through IFX5.
To select different effects types, use the Insert FX Setup page.
For more information, please see "8–1–3: Insert FX Setup"
on page 178.
8–1–4a: Insert Effect 1 (IFX1)
IFX1 On/Off
Turns the insert effect on/off. This is linked with the on/off
setting in the P8–1: IFX– Insert FX Setup page.
Note: If Control Assign is RT Control, you can use switches
1–5 to turn IFX 1–5 on/off.
Ch (Control Channel)
This parameter specifies the MIDI channel that will be used
to control effect dynamic modulation (Dmod), pan
following the insert effect (CC#8), Send 1, and Send 2.
The channel number of the timbre routed through this IFX
will be followed by a "*" displayed at the right of Ch01–16.
If two or timbres with different MIDI channel settings are
routed through the same IFX, this parameter specifies which
of these channels will be used to control the effect.
G ch: The global MIDI Channel (Global 1–1a) will be used
to control the effect. Normally you will set this to G ch.
All-R (All Routed): The channel of any timbre routed
through this effect can be used to control the effect.
(Channels of each routed timbre will be indicated by "*".)
Drum Kits and the MIDI Control Channel
If a Timbre is using a Drum Kit, and the Timbre's Bus Select
(IFX/Indiv. Out Assign) (Combi 8–1–1(2)d) is DKit, this
effects the MIDI Control Channel as well. In this case, the
Timbre's MIDI channel will be used to control any effect
whose Ch is set to All-R, regardless of the Bus Select (Global
5–4b) settings or the settings of the DrumKit IFX Patch
menu command.
P (Effect Preset)
[P00, P01...15, U00...15, ---------------]
Effect Presets let you easily store and recall all of the settings
for an individual effect. You can store up to 16 user presets
for each effect type, in addition to 15 re-writable factory
presets.
The same presets appear in all of the modes (Program,
Combination, Sequencer, and Sampling).
Note that edits to effects parameters are automatically
stored with the Combi–you don't need to store them as an
Effect Preset. Presets just make it easier to re-use your
favorite settings.
8–1
–4
Menu
[Off, On]
[Ch01...16, G ch, All-R]
179