5-8: Velocity Split - Korg M3 Parameter Manual

Send1 (to MFX1)
Send2 (to MFX2)
For each key, specify the send levels to master effects 1 and
2.
These settings are valid when Bus (IFX/Output) Select is set
to L/R or Off. If Bus (IFX/Output) Select is set to IFX1–5, the
send level to master effects 1 and 2 will be determined by
the Program, Combination, or Sequencer mode P8: Insert FX
page parameters Send1 and Send2 which are located after
the sound passes through IFX1–5.
▼5–4: Menu Command
• 0: Write Drum Kits ☞p.387
• 1: Rename Drum Kit ☞p.387
• 2: Copy Drum Kit ☞p.388
• 3: Copy Key Setup ☞p.388
• 4: Swap Key Setup ☞p.388
For more information, please see "Global: Menu Command"
on page 382.
[000...127]
5–8: Velocity Split
[000...127]
5–1a
5–5a
5–8a: Velocity Split
This page graphically shows the zone and crossfade
settings. Edit the drum sample settings while watching both
the Sample Setup page and the Velocity Split page.
DS1(High): (Drumsample1 High)
DS1(High) On/Off
Bottom Velocity
Xfade Range
Curve
In the section "DS1 (High): (Drumsample 1 High)" of "5–1b:
Drumsample" on page 376, please see DS1 (High) On/Off,
Bottom Vel (Bottom Velocity), Xfd (Xfade Range), and Xfade
Curve.
DS2(M Hi): (Drumsample2 Mid High)
DS3(M Lo): (Drumsample3 Mid Low)
DS4(Low): (Drumsample4 Low)
"5–1b: Drumsample" on page 376, please see DS2(M Hi):
(Drumsample2 Mid High), DS3(M Lo): (Drumsample3 Mid
Low), and DS4(Low): (Drumsample4 Low).
▼5–8: Menu Command
• 0: Write Drum Kits ☞p.387
• 1: Rename Drum Kit ☞p.387
• 2: Copy Drum Kit ☞p.388
• 3: Copy Key Setup ☞p.388
• 4: Swap Key Setup ☞p.388
For more information, please see "Global: Menu Command"
on page 382.
Global P5: Drum Kit 5–8: Velocity Split
[Off, 001...127]
[Lin(Linear), Pwr(Power), Lyr(Layer)]
5–5
Menu
[Off, On]
[001...127]
381