0-3: Audio - Korg M3 Parameter Manual

Global mode
KARMA GE
This setting protects the internal KARMA GE memory.
On (checked): The internal KARMA GE memory will be
protected, and the following operations will not be possible.
• Loading KARMA GE data from media
• Receiving KARMA GE data via MIDI data dump
Off (unchecked): You will be able to write to internal
KARMA GE memory.
▼0–2: Menu Command
• 0: Write Global Setting ☞p.382
• 1: Load Preload/Demo Data ☞p.382
• 2: Set Prog User-Bank Type ☞p.382
• 3: Change all bank references ☞p.383
• 4: Touch Panel Calibration ☞p.383
• 5: Half Damper Calibration ☞p.383
• 6: Pad Calibration ☞p.383
• 7: After Touch Calibration ☞p.383
• 8: Update System Software ☞p.384
For more information, please see "Global: Menu Command"
on page 382.
360
[Off, On]
0–3: Audio
0–3a
0–3b
Here you can select the analog/digital audio signal input
sources, and specify their input level, bus, and master effect
sends.
The settings you make in this page are valid in the following
situations:
1. When this page is open.
2. In Program, Combination, and Sequencer modes, if
you've checked Use Global Setting (Prog/Combi 0–7a,
Seq 0–1–7a).
3. In other pages of Global mode, if the mode in which
you were immediately prior to entering Global mode
was in state "2" (above).
4. In Media mode, if the mode in which you were imme-
diately prior to entering Media mode was in state "2"
(above).
0–3a: Input
Input
Here you can adjust the settings for inputting external audio
sources into the M3.
Note: Separate settings can be made for the Analog, S/P DIF
and (FireWire) inputs. First use this Input setting to select a
source, and then set the various parameters for Input1 and
Input2. Multiple external audio sources can be input
simultaneously.
Analog: INPUT 1, 2 jacks will input mic-level or line-level
signals.
S/P DIF: A digital audio signal from the S/P DIF IN jack will
be input. Connect the digital output of your instrument or
DAT etc. to the S/P DIF IN jack. The Input 1 setting below
assigns the input from S/P DIF L, and the Input 2 setting
assigns the input from S/P DIF R. The S/P DIF input/
output supports a sample rate of 48 kHz.
If the EXB-RADIAS is installed, please note the
following points.
• If a 48 kHz system clock is not detected at the S/P
DIF IN jack, the following message will appear, and
you won't be able to switch the System Clock
setting to S/P DIF.
"No 48 kHz clock is detected from S/P DIF Clock
master device. The System Clock cannot be changed
to S/P DIF."
Press EXIT to close the message, and check the con-
nection with the master clock device. Only a 48 kHz
system clock is supported.
• Switching S/P DIF will require several seconds. A
message is displayed while this is occurring. While
this message is displayed, never switch the S/P DIF
clock frequency or disconnect the cable.
[Analog, S/P DIF, (FireWire)]
0–3
Menu