Compaq Smart Array 221 User Manual page 95

7-26 Installing the Operating System Drivers
2. /V
The Verbose mode command line switch is a standard command line
switch that causes the driver to print information to the screen when it
loads. The driver identifies itself along with the current revision. Then
information concerning the adapters and the drives attached to them is
provided. Adapter information includes IRQ, slot number, and
configuration order number. Drive information includes physical and
logical drive count, and the geometry information for each
logical drive.
Example:
3. /A:[adapter index] [unit parameters]
This command line switch is a standard command line switch that causes
the driver to modify its behavior towards adapters.
Where [adapter index] = The adapter index is a number used to identify a
controller. The index is based on '0' for the lowest controller order
number associated with the adapter controlled by this ADD. The index is
incremented by one for each controller in the system as you move up the
controller configuration order.
Writer: Karen Hale Project: Compaq Smart Array 221 Controller User Guide Comments: 388541-001
BASEDEV=CPQARRAY.ADD /V
File Name: H-CH07.DOC Last Saved On: 11/3/98 9:51 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED