Compaq Smart Array 221 User Manual page 134

F-2 POST Error Messages
POST Error Messages
Meaning
1726 Slot x Drive Array - Array Accelerator
Memory Size Change Detected - Array
Accelerator configuration has
automatically been updated
(RESUME = F1 KEY)
1727 Slot x Drive Array - New Logical Drive(s)
Attachment Detected (if >32 logical
drives, this will be followed by Auto-
configuration failed: Too many logical
drives)
(RESUME = F1 KEY)
1729 Slot 1 Drive Array - Disk Consistency
Initialization in Progress – RAID 4/5
performance may be lower until Auto
Reliability Monitoring has completed
Automatic Background Parity Consistency
Initialization.
1766 Slot x Drive Array requires System ROM
Upgrade.
Run System ROMPaq Utility
(RESUME = F1 KEY)
1770
Slot x Drive Array – Critical Drive Firmware
Problem Detected – Please upgrade firmware
on the following drive(s) using Options
ROMPaq (available from www.compaq.com):
SCSI Port (y) SCSI ID ( x )
(RESUME = F1 OR F2 KEY)
Writer: Karen Hale Project: Compaq Smart Array 221 Controller User Guide Comments: 388541-001
continued
File Name: N-APPF.DOC Last Saved On: 11/5/98 12:29 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Recommended Action
This message appears if the controller is
replaced with a model that has a different
amount of cache memory.
This message indicates the controller has
detected an additional array of drives that
was attached when the power was off. The
logical drive configuration information has
been updated to add the new logical drives.
The maximum number of logical drives
supported is 32 - additional drives will not
be added to the configuration. Select F1 key
to resume.
This message is normal following the initial
configuration of RAID 4 or RAID 5 logical
drives. This POST message will go away
and performance of the controller will
improve after the parity data has been
initialized by ARM (an automatic process
that runs in the background on the
controller).
Run the latest version of System ROMPaq.
See Chapter 3 for details.
The indicated drives are running firmware
that is known to cause intermittent
problems. Please use the Compaq "Options
ROMPaq" utility to upgrade firmware on all
drives to the latest revision.
continued