Drives - Compaq Smart Array 221 User Manual

2-8 Installation Preparation
ID5
ID4
ID3
ID2
ID1
ID0
Figure 2-3. Arrays consolidated to one controller
To move an array, make sure all required conditions are satisfied, then:
1. Power system OFF.
2. Move array (include all drives in the array).
3. Power system ON. A 1727 POST message should indicate that logical
drives were added to the configuration.
4. Run the Array Configuration Utility to view the new drive configuration
or to assign spare drives (optional).
Writer: Karen Hale Project: Compaq Smart Array 221 Controller User Guide Comments: 388541-001
Controller 1
y Array B ID5
x ID4
d ID3
c ID2
b Array A ID1
a ID0
CAUTION: It is recommended that you back up your data any
time you move drive arrays or change your configuration.
CAUTION: If the system displays a 1785 (Not Configured) POST
message, turn the system off immediately to avoid data loss and
return the drives to their original locations.
File Name: C-CH02.DOC Last Saved On: 11/5/98 12:27 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Controller 2