Compaq Smart Array 221 User Manual page 138

F-6 POST Error Messages
POST Error Messages
Meaning
1788
Slot x Drive Array Reports Incorrect Drive
Replacement. The following SCSI drive(s)
should have been replaced: SCSI Port ( y ):
SCSI ID ( x ) .
The following SCSI drive(s) were incorrectly
replaced: SCSI Port ( y ): SCSI ID (z).
Select F1 to continue - drive array will
remain disabled.
Select F2 to reset configuration - all
data will
be lost.
1789
Slot x Drive Array Physical Drive(s) Not
Responding. Check cables or replace the
following drives: SCSI Port (y):
SCSI ID (x)
Select F1 to continue - drive array will
remain disabled.
Select F2 to failed drives that are not
responding - Interim Recovery Mode will be
enabled if configured for fault tolerance.
NOTE:
Message 1788 might also be displayed inadvertently due to a bad power cable connection to the
drive or a defective SCSI cable. If this message was due to a bad power cable connection, repair the
connection and press F2. If this message is not eliminated by pressing F2, run the Drive Array Advanced
Diagnostics Utility.
-OR-
If this message was not due to a bad power cable connection, and the drive was not replaced, this could
indicate a defective SCSI cable. Contact your Authorized Compaq Service Provider.
Writer: Karen Hale Project: Compaq Smart Array 221 Controller User Guide Comments: 388541-001
continued
File Name: N-APPF.DOC Last Saved On: 11/5/98 12:29 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Recommended Action
The drives indicated were installed in the wrong
place, so they have been disabled. Reinstall the
drives correctly.
Press F1 to restart the computer with the drive
array disabled.
-Or-
Press F2 to use the drives as configured
and lose all the data on them.
See NOTE below.
This message indicates that previously
operating drives are missing or inoperative
following a cold or warm reset. Turn off system
and check cable connections. If cables are
connected, replace the drive. Press F1 to restart
the computer with the drive array disabled.
-Or-
If you do not want to replace the drives
now, press F2.