Installing The Operating System Drivers; Ibm - Compaq Smart Array 221 User Manual

Chapter 7
Installing the Operating System
Drivers
This chapter outlines the driver installation steps to set up the Smart Array 221
Controller in an existing server with the following operating systems:
Novell NetWare 3.20, 4.11, 5.0
Microsoft Windows NT 3.51, 4.0
SCO OpenServer 5
UnixWare 2.1, 7.1
IBM OS/2 Warp Server Family
Banyan VINES 6.X, 7.X, 8.X
If you are setting up a new system, use the SmartStart and Support Software CD
supplied with the server to install both the operating system and the drivers
necessary to support the Smart Array 221 Controller.
If you install the operating system software from the SmartStart and Support
Software CD, all of the software, including device drivers, are automatically
installed and configured for the Smart Array 221 Controller. The Smart Array
221 Controller is supported by SmartStart 4.21 or later. See the documentation
that came with SmartStart for installation instructions.
Before installing the drivers, you should have:
Updated your system firmware by running System ROMPaq;
Installed the Smart Array 221 Controller option board;
Configured the hardware by running the System Configuration Utility;
Used the Drive Array Configuration Utility to configure your
drive array(s) .
Writer: Karen Hale Project: Compaq Smart Array 221 Controller User Guide Comments: 388541-001
File Name: H-CH07.DOC Last Saved On: 11/3/98 9:51 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Compaq Smart Array 221 Controller User Guide
7-1