Compaq Smart Array 221 User Manual page 126

D-2 Upgrading from the SMART-2SL Array Controller
5. Remove the SMART-2SL Controller and replace it with the Smart Array
221 Controller. It is not necessary to put the new controller in the same
expansion slot as the old controller.
6. Reconnect all internal or external drive cables.
7. Turn on the server and run the Compaq System Configuration Utility
(Version 2.43 or later). It can be run from the SmartStart and Support
Software CD, from the System Partition, or from diskettes. This
configuration utility will recognize the Smart Array 221 Controller and
allow you to change parameters such as controller order and interrupt
number, if desired. You will not see logical drive information with this
utility since Smart Array 221 Controller logical drives are configured
with the Compaq Array Configuration Utility. Save the configuration
and reboot the server.
You can run the Array Configuration Utility to see the configuration of
your logical drive(s), look at fault tolerance level, and so on. However,
this is not necessary since your configuration information is
automatically preserved.
After completing these steps, the upgrade process is complete; you can take full
advantage of the Smart Array 221 Controller.
Writer: Karen Hale Project: Compaq Smart Array 221 Controller User Guide Comments: 388541-001
File Name: L-APPD.DOC Last Saved On: 12/28/98 2:59 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED