Table of Contents
Advertisement
To restore an array to its original controller, make sure the conditions for
moving drives are met. Then:
CAUTION: These steps must be followed EXACTLY. Any deviation or
mistake could result in data loss across all moved arrays.
1.
Power system OFF.
2.
Move the array back to its original controller, but retain its drive position
as it was in the consolidated configuration.
3.
Power system ON.
4.
Each controller will indicate a 1789 POST message that drives are
missing. Press F2 to fail the missing drives.
5.
Run the Array Configuration Utility and remove the appropriate "failed"
arrays.
6.
Reboot the system.
Writer: Karen Hale Project: Compaq Smart Array 221 Controller User Guide Comments: 388541-001
File Name: C-CH02.DOC Last Saved On: 11/5/98 12:27 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Compaq Smart Array 221 Controller User Guide
2-11
Advertisement
Chapters
Table of Contents
