Compaq Smart Array 221 User Manual page 137

POST Error Messages
continued
Meaning
1786
Slot 1 Drive Array Recovery Needed. The
following SCSI drive(s) need Automatic Data
Recovery: SCSI Port 1: SCSI ID 0
Select F1 to continue with recovery of data to
drive .
Select F2 to continue without recovery of
data to drive .
Or
Slot 1 Drive Array Recovery Needed.
Automatic Data Recovery Previously
Aborted! T
he following SCSI drive(s) need
Automatic Data Recovery: SCSI Port 1: SCSI
ID 0
Select F1 to retry Automatic Data
Recovery
Select F2 to continue without starting
Automatic Data Recovery data to
drive.
1787
Slot x Drive Array Operating in Interim
Recovery Mode. The following SCSI
drive(s) should be replaced:
SCSI Port ( y ): SCSI ID ( x )
Writer: Karen Hale Project: Compaq Smart Array 221 Controller User Guide Comments: 388541-001
File Name: N-APPF.DOC Last Saved On: 11/5/98 12:29 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Recommended Action
The message normally appears when a drive
was replaced in a fault-tolerant configuration
when system power was OFF. In this case,
press F1 to start the automatic data recovery
process.
The "previously aborted" version of the
1786 POST message will appear if the
previous rebuild attempt was aborted for
any reason. Run Drive Array Advanced
Diagnostics (DAAD) for more
information. If the replacement drive
was failed, try using another
replacement drive. If rebuild was
aborted due to a read error from another
physical drive in the array, you'll need to
back up all readable data on the array,
run Diagnostics Surface Analysis, and
then restore your data.
Following a system restart, this message
reminds you that drive x is defective and fault
tolerance is being used. Drive x needs
replacement as soon as possible. A loose or
defective cable may also cause this error.
Compaq Smart Array 221 Controller User Guide
F-5
continued