Multifunction Gauge Messages - BRP Can-Am OUTLANDER 400 EFI 2014 Operator's Manual

MULTIFUNCTION GAUGE MESSAGES

MESSAGE
INVALID KEY
PARK BRAKE
LO BATT
HI BATT
LOW OIL (1)
HI TEMP
LIMP HOME
CHECK ENGINE
MAINTENANCE
SOON
NO ECM
COMMUNICATION
NOTICE
(1) If the message and the check engine light stay on after engine
starting, stop engine. Check engine oil level. Refill if necessary. If the oil
level is good, see an authorized Can-Am dealer. Do not use the vehicle until
repaired.
______________
144
INDICATOR
LAMP
Check engine
Parking brake
Check engine
Check engine
Check engine
Check engine
Check engine
Check engine
Check engine
Check engine
DESCRIPTION
Indicates that you have used the wrong
ignition key, use the proper key for this
vehicle. It is also possible that the ignition
key has a bad contact, remove and clean
key.
Is displayed when parking brake is applied
for more than 15 seconds (while riding).
Low battery voltage, check battery voltage
and charging system.
High battery voltage, check battery voltage
and charging system.
Engine low oil pressure, stop engine
immediately.
Engine is overheating, refer to
OVERHEATS TROUBLESHOOTING
in
Serious fault on the engine that can
change the normal operation of the
engine, check engine indicator lamp will
also blink, refer to
Engine fault, check engine indicator
lamp will also
TROUBLESHOOTING
Periodic maintenance required. See an
authorized Can-Am dealer.
Communication
speedometer and engine control module
(ECM), contact an authorized Can-Am
dealer.
ENGINE
TROUBLESHOOTING
be ON, refer
.
error between
.
.
to