Multifunction Gauge Messages - BRP can-am RENEGADE 500 2015 Operator's Manual

MULTIFUNCTION GAUGE MESSAGES

MESSAGE
DESS KEY NOT
RECOGNIZED
PARK BRAKE
LO BATT VOLT
HIGH BATT VOLT
LOW OIL (1)
HI TEMP
LIMP HOME
CHECK ENGINE
MAINTENANCE
REQUIRED (2)
ECM NOT
RECOGNIZED
CHECK DPS
TPS FAULT
PRESS OVERRIDE
BUTTON TO LIMP
HOME
NOTICE
(1)
If the message and the check engine light stay on after engine
starting, stop engine. Check engine oil level. Refill if necessary. If the oil
level is good, see an authorized Can-Am dealer. Do not use the vehicle until
repaired.
(2) Message must be erased by an authorized Can-Am dealer.
______________
136
PILOT LAMP(S)
ON
Check engine
None
Check engine
Check engine
Check engine
Check engine
Check engine
Check engine
Check engine
Check engine
Check engine
Check engine
DESCRIPTION
Indicates that you have used the wrong
ignition key, use the proper key for this
vehicle. It is also possible that the ignition
key has a bad contact, remove and clean key.
Message displayed when brake is applied for
more than 15 seconds (while riding).
Low battery voltage, check battery voltage and
charging system.
High battery voltage, check battery voltage and
charging system.
Engine low oil
immediately.
Engine is overheating,
OVERHEATS TROUBLESHOOTING
in
Serious fault on the engine that can change
the normal operation of the engine, CHECK
ENGINE indicator lamp will also blink, refer to
TROUBLESHOOTING
Engine fault, CHECK ENGINE indicator lamp
will also be ON, refer to
section.
Periodic maintenance
authorized Can-Am dealer.
Communication error between speedometer
and engine control module (ECM), contact an
authorized Can-Am dealer.
Indicates that the DPS (Dynamic Power
Steering) does not work properly. See an
authorized Can-Am dealer.
Throttle position sensor does not work properly.
See an authorized Can-Am dealer.
pressure, stop
refer to
section.
section.
TROUBLESHOOTING
required.
engine
ENGINE
See an