BRP Can-Am OUTLANDER 400 EFI 2014 Operator's Manual page 81

vmo2011-009-001_a
1. Display selector button
2. Time (Display 2)
3. Am/Pm (12-hour format)
4. Message (Display 3)
1. Press and HOLD button (SET TIME
will appear on display 3).
2. Choose the 12-hour (12H) or
24-hour (24H) format by pressing
button.
3. If the 12-hour format was selected,
choose Am ("A") or Pm ("P") by press-
ing button.
4. Press and HOLD button.
5. Choose hour first digit by pressing
button.
6. Press and HOLD button.
7. Choose hour second digit by press-
ing button.
8. Press and HOLD button.
9. Choose minutes first digit by press-
ing button.
10. Press and HOLD button.
11. Choose minutes second digit by
pressing button.
12. Press button to enter settings
(CLOCK will appear on display 3).
CONTROLS/INSTRUMENTS/EQUIPMENT
Display 3 (Mode/Message)
This display will show either an ab-
breviation of the mode selected in
display 2 or will communicate impor-
tant messages to the operator if an
anomaly occurs.
vmo2008-001-020_h
1. Display 3 (mode/message)
2. Display 2 (mode)
Mode Abbreviation
– ODO (odometer)
– TRIP (trip meter)
– TRIP TIME (hour meter)
– ENGINE HOURS (vehicle hour me-
ter)
– RPM
minute)
– CLOCK (Clock).
Display Selector Button
Button used to navigate between
modes or to reset data depending on
the feature selected.
_______________
(engine revolutions per
79