Oil Filter; Maintenance Procedures (Cont'd) - BRP Can-Am OUTLANDER 400 EFI 2014 Operator's Manual

MAINTENANCE PROCEDURES
Torque plug to 30 N•m ± 3.6 N•m
(22 lbf•ft ± 3 lbf•ft).
Replace the oil filter.
Refill engine at the proper level with
the recommended oil. Engine oil ca-
pacity with filter replacement is 3 L
(3.2 qt (U.S. liq.)).
Start engine and let idle for a few min-
utes. Ensure oil filter and oil drain plug
areas are not leaking.
Stop engine.
Wait a while to allow oil to flow down to
crankcase then check oil level. Refill as
necessary.
Dispose of oil as per your local environ-
mental regulations.

Oil Filter

Oil Filter Replacement
On the right side of vehicle, remove en-
gine cover.
vmo2008-019-025_a
RH SIDE OF VEHICLE
1. Engine cover
Unscrew the oil filter cover.
______________
110
vmo2008-019-024_a
1. Oil filter cover
Remove the oil filter screws, cover
with O-ring and oil filter.
R400motr111A
1. Oil filter screws
2. Oil filter cover
3. O-ring
4. Oil filter
Check the cover O-ring and change it if
necessary.
Check and clean the oil filter inlet and
outlet area for dirt and other contami-
nations.
4 3 2 1