BRP Can-Am OUTLANDER 400 EFI 2014 Operator's Manual page 47

ITEMS TO BE
INSPECTED
Cargo
Service and storage
compartments
Chassis and
suspension
What to Do Before Starting the Engine (Key ON)
ITEMS TO BE
INSPECTED
Multifunction gauge
Lights
What to Do After the Engine is Started
ITEMS TO BE
INSPECTED
Steering
Shift lever
2WD/4WD selector
Brakes
Emergency engine
stop switch
Ignition switch
________
INSPECTION TO PERFORM
If you transport a cargo, respect the load capacity. Ensure
cargo is properly secured to the racks
If you are pulling a trailer or an other equipment:
– Check hitch and trailer ball condition
– Respect the tongue capacity and towing capacity
– Ensure trailer is properly secured to hitch.
Check if front service compartment and rear storage
compartment are properly latched
Check underneath vehicle for any debris on chassis or
suspension and clean them properly
INSPECTION TO PERFORM
Check operation of indicator lamps in multifunction gauge
(during first few seconds of key ON)
Check for messages on multifunction gauge
Check operation and cleanliness of headlights and taillight
Check operation of high and low beam
Check operation of brake light
INSPECTION TO PERFORM
Check if steering operates freely by completely turning it
from side to side
Check operation of shift lever (P, R, N, H and L)
Check operation of 2WD/4WD selector
Drive forward slowly a few feet and apply all brakes
individually to test them. The brakes must fully apply.
Lever and pedal must fully return when released.
Check that the emergency engine stop switch is working
properly
Check if ignition switch is working properly by restarting
and stopping the engine
SAFETY INFORMATION
RIDING THE VEHICLE
________
✔
✔
✔
45