TIRE PRESSURE - 1-UP MODELS
Total Load
Allowed
Max.
UP to
227 kg
(500 lb)
Min.
TIRE PRESSURE - 2-UP MODELS
Total Load
Allowed
Max.
UP to
235 kg
(517 lb)
Min.
Although the tires are specifically de-
signed for off-road use, a flat may still
occur. Therefore, it is recommended
to carry a tire pump and a repair kit.
Tire Inspection
Check tires and rims for damage.
Also, check tires for wear. Replace if
necessary.
Do not rotate tires. The front and rear
tires have a different size. The tires are
directional and their rotation must be
kept in a specific direction for proper
operation.
FRONT
REAR
48 kPa
48 kPa
(7 PSI)
(7 PSI)
34.5 kPa
34.5 kPa
(5 PSI)
(5 PSI)
FRONT
REAR
48 kPa
48 kPa
(7 PSI)
(7 PSI)
34.5 kPa
34.5 kPa
(5 PSI)
(5 PSI)
______________
MAINTENANCE PROCEDURES
Tire Replacement
WARNING
– When the tires are replaced,
never install a bias tire with a
radial tire. Such a combination
could create handling and/or
stability problems.
– Do not mix tires of different size
and/or design on the same axle.
– Front and rear tire pairs must
have an identical model and
manufacturer.
– For unidirectional tread pat-
tern, ensure that the tires are
installed in the correct direction
of rotation.
– The radial tires must be in-
stalled as a complete set.
Wheel Bearing Inspection
Push and pull the wheels from the up-
per edge to feel the play.
See an authorized Can-Am dealer if
there is any play.
V07H03Y
Wheel Removal and Installation
Loosen nuts then lift vehicle.
123