Multifunction Gauge Messages - BRP CAN-AM OUTLANDER 6x6 2017 Series Operator's Manual

MULTIFUNCTION GAUGE MESSAGES

MESSAGE
BAD KEY
DESS KEY NOT
RECOGNIZED
PARK BRAKE
LO BATT VOLT
HIGH BATT VOLT
(1)
LOW OIL
HI TEMP
LIMP HOME
CHECK ENGINE
ECM NOT
RECOGNIZED
CHECK DPS
MAINTENANCE
(2)
REQUIRED
TPS FAULT PRESS
OVERRIDE BUTTON TO
LIMP HOME
NOTICE
(1) If the message and the check engine light stay on after engine
starting, stop engine. Check engine oil level. Refill if necessary. If the oil
level is good, seek service from an authorized Can-Am dealer, repair shop
or person of your own choosing for maintenance, repair or replacement.
Please refer to the US EPA Emissions-related warranty contained herein for
information about warranty claims. . Do not use the vehicle until repaired.
(2)
To erase the MAINTENANCE REQUIRED message, proceed as follows:
1. From main display (vehicle speed), press SET and HOLD.
2. Alternate between LOW beam and HIGH beam 3 times.
NOTE: Step 2 must be completed within 2 seconds.
3. Release SET button.
______________
176
PILOT
LAMP(S) ON
Indicates that you have used the wrong D.E.S.S. key, use the
Check engine
proper key for this vehicle.
Indicates that there possibly is a bad contact, remove and clean
Check engine
key.
Displayed when brake is applied for more than 15 seconds
Parking brake
(while riding).
Low battery voltage, check battery voltage and charging
Check engine
system.
High battery voltage, check battery voltage and charging
Check engine
system.
Check engine Engine low oil pressure, stop engine immediately.
Engine is overheating, refer to
Check engine
TROUBLESHOOTING
Serious fault on the engine that can change the normal
Check engine operation of the engine, CHECK ENGINE indicator lamp will
also blink, refer to
Engine fault, CHECK ENGINE indicator lamp will also be ON,
Check engine
refer to
Communication error between speedometer and engine control
Check engine
module (ECM).
Indicates that the DPS (Dynamic Power Steering) does not work
Check engine
properly.
None Displayed in gauge when vehicle is due for a maintenance
Throttle position sensor does not work properly. Seek service
from an authorized Can-Am dealer, repair shop or person of your
Check engine own choosing for maintenance, repair or replacement. Please
refer to the US EPA Emissions-related warranty contained
herein for information about warranty claims.
DESCRIPTION
section.
TROUBLESHOOTING
TROUBLESHOOTING
section.
ENGINE OVERHEATS
section.
in