Multifunction Gauge - BRP Can-Am OUTLANDER 400 EFI 2014 Operator's Manual

Press and hold the override button,
then depress throttle lever gradually.
NOTE: When using the override func-
tion, the multifunction gauge will scroll
an OVERRIDE message to confirm
that the function is properly activated.
WARNING
Never activate the override button
if the throttle is applied as a loss of
control may result.
WARNING
If driving downhill in reverse,
gravity can increase the vehicle
speed above the set limited re-
verse speed.
vmo2012-005-001_c
1. Override button
2. Emergency engine stop switch

10) Multifunction Gauge

The multifunction gauge is located in
the middle of the handlebar.
WARNING
Selecting various numerical dis-
plays, system modes of opera-
tion or changing settings should
only be carried out with the vehicle
stopped. Selecting these various
functions while operating the vehi-
cle at speed is not recommended
as it deters your attention from sit-
uational awareness.
CONTROLS/INSTRUMENTS/EQUIPMENT
vmo2008-001-020_l
TYPICAL
1. Display 1 (speedometer)
2. Display 2 (mode)
3. Display 3 (mode/message)
4. Display selector button
5. Tachometer
6. Transmission position display
7. Fuel level display
8. Indicator lamps
Unit Selection (MPH vs km/h)
This multifunction gauge is factory pre-
set in Metric units but it is possible to
change it to Imperial units, contact an
authorized Can-Am dealer for unit set-
tings.
NOTE: All features will have their units
changed all together.
vmo2008-001-020_b
1. Unit selection
_______________
77