Messages In Multifunction Gauge - BRP Can-am MAVERICK Trail T Series Operator's Manual

MESSAGES IN MULTIFUNCTION GAUGE

If an abnormal engine condition occurs, the following messages can be combined
with a pilot lamp.
MESSAGE
D.E.S.S. KEY NOT
RECOGNIZED
BAD KEY
CHECK ENGINE
LIMP HOME
TPS FAULT
BRAKE FAILURE
CHECK DPS
(models with DPS)
PPS FAULT
FUEL SENSOR
FAULT
BRAKE FAILURE
- LOW BRAKE
FLUID
______________
150
D.E.S.S. key requires cleaning.
Indicates that you have used the wrong D.E.S.S. key, use the
proper key for this vehicle.
All active or previously activated faults that require attention.
No engine limitation engaged.
Critical faults requiring diagnostic as soon as possible.
An engine limitation is engaged and/or the engine behavior is
modified.
Throttle body fault, generally followed by a Limp Home message.
Brake signal fault.
Check engine pilot light on. Indicates that the DPS (Dynamic
Power Steering) does not work properly. See an authorized
Can-Am dealer.
Faulty Pedal Position Sensor(s) (PPS). Make sure pedal position
sensor connector is fully engaged. See an authorized Can-Am
dealer.
When the fuel sender resistor value is out of range the
multifunction gauge (analog/digital) will detect it and display the
message.
When one or two of the two low brake fluid level sensor detect
low brake fluid
DESCRIPTION