Hardware Conditions To Enter The Isp Mode - Abov MC80F0304 User Manual

MC80F0304/08/16
Function
Load HEX File
Save HEX File
Erase
Blank Check
Program
Read
Verify
Lock
Erase Option
AUTO
Auto Lock
Connect
Edit Buffer
Fill Buffer
Goto
OSC. ______ MHz
Start ______
End ______
Checksum
Com Port
Baud Rate
Select Device
Page Up Key
Page Down Key

26.3 Hardware Conditions to Enter the ISP Mode

The boot loader can be executed by holding ALEB high, RST/
V as +9V, and ACLK(optional) with OSC. 1.8432MHz. The
PP
ISP function uses following pins: TxD, RxD, ALEB, ACLK and
RST/V .
PP
Note: If POR and R35 are enabled, Vdd and Vpp should
be turned on simultaneously to enter ISP mode.
122
Load the data from the selected file storage into the memory buffer.
Save the current data in your memory buffer to a disk storage by using the Intel Motorolla HEX
format.
Erase the data in your target MCU before programming it.
Verify whether or not a device is in an erased or unprogrammed state.
This button enables you to place new data from the memory buffer into the target device.
Read the data in the target MCU into the buffer for examination. The checksum will be displayed
on the checksum box.
Assures that data in the device matches data in the memory buffer. If your device is secured, a
verification error is detected.
Secures devices so that their content can no longer be examined or modified.
-
Erase & Program & Verify
If selected with check mark, the security locking is performed after erasure.
Connect a MCU in your target Board with displaying as "Connected" in the status box. Users have
to press this button at least one time to initialize a target MCU for entering the ISP mode. If failed
to enter the ISP mode, all the buttons are unavailable. And, after entering successfully, the
Connect button will be unavailable.
Modify the data in the selected address in your buffer memory
Fill the selected area with a data.
Display the selected page.
Enter your target system's oscillator value with discarding below point.
Starting address
End address
Display the checksum(Hexdecimal) after reading the target device.
Select serial port.
Select UART baud rate.
Select target device.
Display the previous page of your memory buffer.
Display the higher page than the current location.
Table 1. ISP Function Description
Description
Normal sequence above can not enter ISP mode when
POR and R35 options are enabled.
Please follow below sequence instead of normal one.
1) Power off a target system.
2) Configure a target system as ISP mode.
3) Attach a ISP B/D into a target system.
4) Run the ISP S/W
November 4, 2011 Ver 2.12