Table of Contents
Advertisement
1
Versions, Scope of Delivery and Installation References
See "Figure 1: page 8"
Canopy fixing elements
Pre-assembled components
Pre-assembled or loose components
incl. in the scope of delivery
(see Chapter 15.5 on Page 76)
Motor arm fixing elements
Loose components
incl. in the scope of delivery
Fixing elements for
additional ceiling tube
Pre-assembled components
Console tube fixing elements
Console tube fixing elements mounted to the
Interface plate (Single / Duo) – pre-assembled
1
Intermediate ceiling – installed by the customer on site
2
1.2
Scope of delivery of the motor arm, Navigator Lift
Single arm
The scope of delivery can vary depending on the individual order.
Canopy (Single / Duo) (Flat / High) (depending on the version)
3
Installation as described in Chapter 14 on Page 66
–
1 Single canopy Ø 600mm x 150mm, 1 canopy attachment 110mm high
–
1 Single canopy – 700mm x 700mm x 150mm high
–
1 Duo canopy (installation with intermediate ceiling) – 700mm x 700mm x 50mm
–
1 Duo canopy (installation with intermediate ceiling) – 700mm x 700mm x 150mm
–
1 canopy attachment – 700mm x 700mm x 120mm high
–
4 / 6 threaded bolts M10 x 360mm, 4 / 6 hexagonal nuts M10
–
4 / 6 metal screws, 4 / 6 cover screws and 1 sectional strip
Motor arm with ceiling tube (pre-assembled)
4
Installation as described in Chapter 8 on Page 36
–
1 motor arm
–
1 power supply cable
–
Supply cable for electromagnetic brake
–
1 signal cable for electromagnetic brake (in protective tube)
–
3 earthing cables 4mm² (2 earthing cables for unassembled ceiling tube)
–
1 setscrew M16 – DIN EN ISO 4028,
–
2 ball stops Ø 12.7mm
–
2 voltage selection plugs for the selection of the 120V / 230V power supply
–
2 side panels, front right / left joint for motor arm
–
1 cover, front joint, for motor arm
–
2 cover straps, front joint, for motor arm
–
2 side panels, front right / left joint, for motor arm
–
1 cover, rear joint, for motor arm
–
2 cover straps, rear joint, for motor arm
–
12 hexagonal nuts M16 and 6 spring rings, 12 flat washers external Ø 34mm and
12 plastic insulating discs, 6 threaded bolts M16 x 330mm
Extended motor arm ceiling tube
6
Pre-installation as described in Chapter 7 on Page 32
–
1 ceiling tube (length as specified in the order)
–
1 earthing cable, 4mm²
–
1 socket wrench extension (for 500 and 700mm ceiling tube length only)
–
8 Allen cylinder screws M10 x 25mm – 8.8 – DIN EN ISO 4762
–
8 lock washers S10
Console tube
7
Installation as described in Chapter 9 on Page 42
–
1 console tube (in order-specific length)
–
1 earthing cable, 4mm²
–
8 Allen countersunk screws M10 x 18mm – 10.9 – DIN EN ISO 10642
–
included in the scope of delivery of the Navigator M6
Navigator M6
9
150 / 250
™
1568911, Edition 2019-04, Version 0
EN
Advertisement
Table of Contents
