Table of Contents
Advertisement
15
Adjustments
Figure 61: Mounting the swivel stop
Nm
1568911, Edition 2019-04, Version 0
1
2
340°
1
3
4
1
3
4
15.6.3 Mounting the swivel stop
(See "Figure 61")
1.
Follow the general safety instructions prescribed in Chapter 15.1 on
Page 72.
2.
The assignment and size of the setscrew① and the ball stop③ for
the different pendant system versions are described in Chapter
15.6.1, "Versions", on page 77.
3.
Unscrew a setscrew① from the threaded hole ②.
4.
Rotate the extension arm or XL extension arm or motor arm towards
the desired end stop position and then insert 1 ball stop③ into the
threaded hole②.
NOTE – Make sure that the ball stop is securely in place
If the ball stop③ has completely snapped into place in one of the mount-
ing fixtures④, the extension arm or motor arm can be rotated. Otherwise,
it is blocked and the ball stop③ must be pushed into one of the mounting
fixtures④ using a screwdriver whilst gently rotating the extension arm or
motor arm.
5.
Rotate the extension arm or motor arm into the desired second end
stop position and then insert 1 additional ball stop③ into the thread-
ed hole②.
6.
Slightly rotate the extension arm or motor arm and then screw the
setscrew① into the threaded hole② as far as it will go.
•
The setscrew① only serves as an end stop for the ball stop③
mounted and restricts the swivel range of the extension arm or motor
arm.
Risk of internal supply cables twisting off
The swivel stop can fail if the fixing elements have not
been properly tightened, and the supply cables can twist
off:
• Tighten the setscrew M16① or setscrew M20① to
40Nm.
7.
Tighten the setscrew① to the prescribed tightening torque.
8.
To check that the swivel stop operates securely:
•
The swivel range of the extension arm or the motor arm must be
restricted to less than 360 degrees.
9.
To change a mounted ball stop③, refer to Chapter 15.6.4, "Disman-
tling the swivel stop", on page 79.
78
WARNING
EN
Advertisement
Table of Contents
