Table of Contents
Advertisement
14
Mounting the Canopy, Cover Caps and the Cover Panels
Figure 50: Mounting the cover plates to the motor arm
14.4 Mounting the cover plates to the motor arm
(See "Figure 50")
The Figure shows the motor arm
extension arm with motor arm
version is identical.
5
The Figure shows a simplified representation with only the motor arm
without cables.
14.4.1 Inserting the rear cover plates
(See "Figure 50")
Damage to the cover plates
If the front cover plate is confused with the rear cover
plate or vice versa, there is a risk of the cover plates being
damaged and becoming unusable.
• Observe the cover plate positions indicated
in the description below.
1.
Place the 2 rear cover plate halves① (motor side), see the 2
cutouts②, around the motor arm.
•
The upper and the lower cover plates are not identically constructed.
•
In addition, the lower cover plate can be easily distinguished due to
its rounded corners③.
2.
To make sure that the cover plate halves securely snap into place,
put them inside each other in the correct position ⑤ illustrated in the
Figure and then stick them together in the direction of the arrow.
å
The cover plate halves engage with each other and are connected.
3.
Check that the cover plate halves① are securely in place:
•
All the latches on the cover plate halves① must be securely engaged
with each other.
14.4.2 Mounting the front cover plates
(See "Figure 50")
4.
Repeat procedure for the 2 front cover plate halves④ (without cut-
outs②).
69
. The installation procedure for the
4
or the XL extension arm with motor arm
5
NOTICE
1568911, Edition 2019-04, Version 0
EN
4
Advertisement
Table of Contents
