Table of Contents
Advertisement
15
Adjustments
Figure 62: Dismantling the swivel stop
Nm
15.6.4 Dismantling the swivel stop
(See "Figure 62")
1.
Follow the general safety instructions prescribed in Chapter 15.1 on
Page 72.
2.
The assignment and size of the setscrew① and the ball stop③ for
the different pendant system versions are described in Chapter
15.6.1, "Versions", on page 77.
3.
Unscrew a setscrew① from the threaded hole ②.
4.
Rotate the extension arm or XL extension arm or motor arm until the
ball stop③ in the threaded hole② is visible.
5.
Using a telescopic magnet pick-up tool, remove the ball stop③ from
the threaded hole② and keep it in a safe place.
1
Electric shock hazard
2
In order to prevent the internal supply cables twisting off,
at least 1 ball stop must be mounted. This individual ball
stop serves as twist protection:
• Mount the swivel stop directly afterwards.
• Mount at least 1 ball stop④ in order to restrict the
swivel range of the extension arm or the motor arm to
340 degrees.
6.
Mount the swivel stop as described in Chapter 15.6.3 on Page 78.
1
3
4
79
WARNING
1568911, Edition 2019-04, Version 0
EN
Advertisement
Table of Contents
