Table of Contents
Advertisement
18
Technical Data
Modes of operation
Duty cycle of the
height adjustment mechanism
Duty cycle of the
electromagnetic brakes
the pendant system*
Dead weight of the ceiling tube
for the extension arm
Dead weight of the ceiling tube
for the XL extension arm
Dead weight of the console tube
1568911, Edition 2019-04, Version 0
•
The pendant systems Navigator Lift
Navigator Lift
operation.
•
The maximum duty cycle of the height adjustment mechanism on the motor arm must
not exceed 3 minutes:
–
If the height adjustment mechanism is actuated over a longer period of time, the
electric motor of the motor arm may switch off automatically as a protection measure
against overheating.
–
In order to prevent an overload of the electric motor, make sure you wait at least 30
minutes after actuating the height adjustment mechanism before putting the height
adjustment mechanism into operation. Afterwards the height adjustment mechanism
can be operated once again for 3 minutes.
•
The maximum duty cycle of the electromagnetic brakes must not exceed 1 minute:
–
If the electromagnetic brakes are actuated over a longer period of time, the power
pack may switch off automatically as a protection measure against overheating.
–
Once the power pack has switched off, it must cool down for 10 minutes and then be
disconnected from the mains for 10 seconds before being switched back on again.
Normal system operation can only be resumed afterwards.
Rating plate
•
The rating plates are attached to the top side of the extension arm or XL extension
arm and under the front cover of the motor arm (see Chapter 2.8 on Page 19).
Dead weight of
Motor arm 150 / 250 (1015mm long).......................................................................... 58kg
Extension arm, 600mm, with motor arm 150 (1015mm long) .................................... 83kg
Extension arm, 800mm, with motor arm 150 (1015mm long) .................................... 86kg
Extension arm, 1000mm, with motor arm 150 (1015mm long) .................................. 89kg
Extension arm, 1200mm, with motor arm 150 (1015mm long) .................................. 92kg
XL extension arm, 600mm, with motor arm 250 (1015mm long) ............................... 99kg
XL extension arm, 800mm, with motor arm 250 (1015mm long) ............................. 104kg
XL extension arm, 1000mm, with motor arm 250 (1015mm long) ........................... 109kg
XL extension arm, 1200mm, with motor arm 250 (1015mm long) ........................... 114kg
XL extension arm, 1400mm, with motor arm 250 (1015mm long) ........................... 119kg
XL extension arm, 1600mm, with motor arm 250 (1015mm long) ........................... 124kg
* Without gas hoses and supply cables inserted, without ceiling or console tube and with-
out optional accessories.
Flange .......................................................................................................................... 6kg
Steel tube .............................................................................................................. 24kg/m
Flange ....................................................................................................................... 7.5kg
Steel tube ........................................................................................................... 31.7kg/m
Bearing unit ................................................................................................................. 5kg
Console tube ........................................................................................................... 8kg/m
™
150 Single, Navigator Lift
™
™
150 Dual, Navigator Lift
84
™
250 Single,
XL 250 Dual are suitable for continuous
EN
Advertisement
Table of Contents
