Table of Contents
Advertisement
6
Mounting Threaded Bolts to the Interface Plate
Figure 9: Cutting and installing the threaded bolts for the Sin-
gle / Duo interface plate on the raw ceiling
6.1
Mounting situation: Mounting the interface plate
to the raw ceiling without intermediate ceiling
6.1.1 Versions
(See "Figure 9")
The following Figures illustrate the interface plate
shape), for installing the motor arm and motor arm with extension arm
versions.
The steps required for installation on the interface plate
(squared shape) are identical.
6.1.2 Cutting the threaded bolts to length
(See "Figure 9")
If a Single / Duo interface plate
6 (Single version) or 12 (Duo version) threaded bolts M16 x 330mm③
must be cut to length.
The Single / Duo canopy
3
with the raw ceiling and covers the ceiling tube flange.
1.
For a canopy
which is 260mm high the 6/12 threaded bolts
3
M16 x 330mm③ must be cut to 240mm.
2.
Slightly deburr the 6/12 threaded bolts M16 x 330mm① in order to
ensure maximum thread engagement into the interface plate
6.1.3 Mounting the threaded bolts
(See "Figure 9")
1.
Screw 1 hexagonal nut M16② each onto the 6/12 threaded bolts
M16③ and then place 1 spring ring① each.
Pendant system dropping
If the threaded bolts M16③ are not completely screwed
in, they may break out of the interface plate
the pendant system to drop:
• Make sure that all shortened threaded bolts M16③
are completely screwed into the interface plate
to the end stop on the raw ceiling.
Pendant system dropping
The pendant system can drop if the fixing elements have
not been properly tightened:
• Tighten all hexagonal nuts M16② with a tightening
torque of 195Nm.
2.
Check that the shortened threaded bolts M16③ are securely in
place at the correct distances to each other:
•
The threaded bolts M16③ must be completely screwed into the
interface plate
.
1
•
The 6/12 hexagonal nuts M16② must be tightened to 195Nm.
3.
Continue the installation as described in Chapter 6.1.4 on Page 26.
25
, Single (round
1
1
is mounted to the raw ceiling, the
1
with attachment to be mounted later is flush
WARNING
1568911, Edition 2019-04, Version 0
EN
Single
.
1
and cause
1
up
1
Advertisement
Table of Contents
