Table of Contents
Advertisement
14
Mounting the Canopy, Cover Caps and the Cover Panels
Figure 48: Mounting the cover caps
Figure 49: Dismantling the cover caps
1568911, Edition 2019-04, Version 0
14.3 Mounting/dismantling the cover caps to/from the
extension arm
14.3.1 Mounting the cover caps
(See "Figure 48")
The Figure shows the extension arm with motor arm
procedure for the XL extension arm with motor arm
cal.
The Figure shows a simplified representation with only the extension arm
with motor arm
or the XL extension arm with motor arm
5
bles. The detailed representation shows a sectional view of the cover
cap①.
1.
When placing the cover cap① onto the extension arm end, make
sure that the holding down clamp② sits in the aperture④.
2.
Push the cover cap① onto the extension arm with motor arm
the XL extension arm with motor arm
make sure that the latch③ snaps into place in the groove⑤:
•
Make sure that the cables in the extension arm with motor arm
the XL extension arm with motor arm
•
If properly mounted, the cover cap① can no longer be withdrawn
from the extension arm with motor arm
with motor arm
.
5
3.
Check that the cover cap① is securely in place:
•
The cover cap① muss be absolutely level with the contours of the
extension arm with motor arm
arm
.
5
14.3.2 Dismantling the cover caps
(See "Figure 49")
The Figure shows the extension arm with motor arm
procedure for the XL extension arm with motor arm
cal.
The Figure shows a simplified representation with only the extension arm
with motor arm
or the XL extension arm with motor arm
5
bles. The detailed representation shows a sectional view of the cover
cap① .
1.
To dismantle the cover cap① push a small, flat screwdriver be-
tween the cover cap① and the extension arm with motor arm
the XL extension arm with motor arm
latch② out of the groove④.
•
Make sure you do not damage the paint of the extension arm.
•
Make sure you do not damage the latch②.
•
Make sure that the cover cap① neither breaks nor bends.
2.
Pull the cover cap① backwards until the holding down clamp③ no
longer engages and the cover cap① can be freely moved.
•
Do not twist the cover cap① and do not remove it with force.
3.
Remove the cover cap① towards the top and keep it in a safe
place.
68
. The installation
5
version is identi-
5
without ca-
5
as far as it will go and
5
are not damaged.
5
or the XL extension arm
5
or the XL extension arm with motor
5
. The installation
5
version is identi-
5
without ca-
5
and gently push the
5
EN
or
5
or
5
or
5
Advertisement
Table of Contents
