Table of Contents
Advertisement
8
Mounting the Ceiling Tube to the Threaded Bolts of the Interface Plate
Figure 22: Aligning the motor arm / extension arm with the
interface plate, Single
1568911, Edition 2019-04, Version 0
8.3
Aligning the motor arm / extension arm with the
interface plate, Single
(See "Figure 22")
The Figure only shows a simplified representation of the flange③ with
ceiling tube to be mounted to the threaded bolts. Further components
pre-assembled to the flange③, such as the motor arm, extension arm,
cables, etc., are not represented.
NOTE – Positioning problems and inclination
Precise horizontal alignment is essential in order to ensure that the pen-
dant system can be freely moved and securely positioned, and to avoid
inclination.
Pendant system dropping
The pendant system can drop if the fixing elements have
not been properly tightened:
• Tighten all hexagonal nuts M16② on the flange with a
tightening torque of 100Nm.
1.
Choose 1 of the 6 hexagonal nuts M16② as a reference point.
2.
Screw the 6 hexagonal nuts M16② under the flange③ crosswise
onto the flange③ and tighten them to 100Nm.
Destruction of the cables in the extension arm / motor arm
There is a risk of destroying or damaging the cables in the
extension arm / motor arm if an extension arm / motor arm
is rotated more than 360 degrees:
• Do not rotate the motor arm
with motor arm
arm
more than 350 degrees.
5
• If required, restrict the swivel range of the motor arm
or the extension arm with motor arm
4
extension arm with motor arm
Chapter 15.6 on Page 77.
3.
Remove the transport lock (band) from the extension arm with motor
arm
or the XL extension arm with motor arm
5
and dismantle the pre-assembled swivel stop as described in
Chapter 15.6.4 on Page 79 if required. Next, turn the lower exten-
sion arm into the extension of the upper extension arm.
4.
Continuation on the next page.
38
WARNING
NOTICE
or the extension arm
4
or the XL extension arm with motor
5
5
as described in
5
– Dual arm type
5
EN
or the XL
Advertisement
Table of Contents
