Mounting The Threaded Bolts To The Single / Duo Interface Plate - Nuvo Navigator Lift 150 Single Installation Instructions Manual

6 Mounting Threaded Bolts to the Interface Plate
Figure 12: Mounting the upper insulations to the threaded
bolts
1568911, Edition 2019-04, Version 0
6.2.3 Mounting the threaded bolts to the Single / Duo interface
plate
(See "Figure 12")
1. Screw 1 hexagonal nut M16② each onto the 6/12 threaded bolts
M16③ and then place 1 spring ring① each.

Pendant system dropping
If the threaded bolts M16③ are not completely screwed
in, they may break out of the interface plate
the pendant system to drop:
• Make sure that all shortened threaded bolts M16③
are completely screwed into the interface plate
to the end stop on the raw ceiling.
Pendant system dropping
The pendant system can drop if the fixing elements have
not been properly tightened:
• Tighten all hexagonal nuts M16② with a tightening
torque of 195Nm.
2. Check that the shortened threaded bolts M16③ are securely in
place at the correct distances to each other:
• The shortened threaded bolts M16③ must be completely screwed
into the interface plate
1
• The 6/12 hexagonal nuts M16② must be tightened to 195Nm.
3. Continue the installation as described in Chapter 6.2.4 on Page 29.
28
WARNING
1
.
EN
and cause
up
1