Mounting The Brake Indicators (For Retrofit Only) - Nuvo Navigator Lift 150 Single Installation Instructions Manual

Table of Contents

Advertisement

10
Mounting Optional Accessories
Figure 29: Mounting the brake indicators

10.2 Mounting the brake indicators (for retrofit only)

(See "Figure 29")
Upon delivery of the system from the factory the following optional
accessories are pre-assembled:
The Figure shows the extension arm with motor arm
procedure for the XL extension arm with motor arm
cal.
The brake indicators
are mounted to the swivel or brake points of the
9
motor arm
or the extension arm with motor arm
4
arm with motor arm
. Four brake indicators
5
arm version, whereas 2 brake indicators are mounted to the Single arm
version.
1.
Gently disengage the 2 / 4 pre-assembled plastic covers① on all 4
latches②, remove them and keep them in a safe place.
2.
Plug 1 power cable connector③ onto the connector socket⑦ of the
lighting board⑤.
Colour code of the lighting boards⑤:
Upper bearing = green (No. 1546534)
Intermediate bearing = blue (No. 1546650)
3.
Route the power cable③ through the hole⑥ (see arrow) into the ex-
tension arm / motor arm.
Make sure that the plugs and the power cable③ are not damaged.
The power cable③ must sit entirely in the extension arm / motor arm.
4.
Hook the lighting board⑤ at the bottom side into the mounting
aperture④ and gently push it in until it audibly snaps into place.
Do not push the lighting board⑤ into the mounting aperture④ with
force.
5.
Check that the lighting board⑤ is securely in place:
The lighting board⑤ must sit in the mounting aperture④ without
being wedged.
NOTE – Colour code of the plastic covers
Navigator Lift
pendant system – Dual arm:
The upper plastic cover① is green
The lower plastic cover① is blue
Navigator Lift
pendant system – Single arm:
The plastic cover① is green
6.
Gently push the 2 / 4 plastic covers① into the mounting aperture④
until the 4 latches② audibly snap into place.
7.
Check that the plastic covers① are securely in place:
The plastic covers① must sit in the mounting aperture④ without
being wedged.
45
. The installation
5
version is identi-
5
or the XL extension
5
are mounted to the Dual
9
1568911, Edition 2019-04, Version 0
EN

Advertisement

Table of Contents
loading

Table of Contents