Table of Contents
Advertisement
10
Mounting Optional Accessories
Figure 28: Mounting the extension arm lighting
1568911, Edition 2019-04, Version 0
10.1 Mounting the Extension Arm Lighting (for Retro-
fit only)
(See "Figure 28")
Upon delivery of the system from the factory the following optional
accessories are pre-assembled:
The Figure shows the extension arm with motor arm
procedure for the XL extension arm with motor arm
cal.
The indirect extension arm lighting
of 800mm possible, for XL extension arms from a length of 1000mm pos-
sible) is mounted to the top side of the extension arm.
The Figure shows a simplified representation with only the extension arm
with motor arm
or the XL extension arm with motor arm
5
pre-assembled cables.
1.
Dismantle the 3 sealing plugs (not illustrated) from the top side of
the extension arm and dispose of them in compliance with statutory
regulations.
2.
Route the connecting cable④ on the basic carrier with LED③
through the mounting aperture⑤ into the extension arm without
bending it.
3.
Route the cables through the pendant system and connect them as
described in Chapter 11.5.3 on Page 50.
4.
Place the cover① onto the basic carrier with LED③ and screw it on
using 2 countersunk screws M4 x 16mm② – DIN EN ISO 10642.
5.
Check that the extension arm lighting
•
The extension arm lighting
•
The connecting cable④ on the basic carrier with LED③ must sit in
the extension arm.
•
The 2 countersunk screws M4 x 16mm② – DIN EN ISO 10642 must
be screwed on.
44
. The installation
5
version is identi-
5
(for extension arms from a length
8
5
is securely in place:
8
must be level with the extension arm.
8
EN
without
Advertisement
Table of Contents
