Table of Contents
Advertisement
12
Connecting the Supply Cables and Hoses
Abbildung 42: Replacing the fuse
12.4.2 Replacing the fuse
(See "Figure 42")
If the fuse blows, it can be replaced.
1.
Observe the safety instructions in Chapter 12.1 on Page 60.
2.
If required, swing the electronic unit out of the motor arm as de-
scribed in Chapter 11.3 on Page 47.
3.
Unlock the cover① via the two unlocking mechanisms on the sides
and then remove the cover①.
4.
Remove the fuse② from its holder.
5.
Insert a fuse② which complies with the following values:
•
Fuse, 5 x 20mm, 8 A, 250 VAC, slow-blow, high breaking capacity
•
Inscription on the fuse: T 8 A H 250 V
6.
Place the cover① and lock it in position via the corresponding
mechanisms on the sides.
7.
Check that the cover① is securely in place.
63
1568911, Edition 2019-04, Version 0
EN
Advertisement
Table of Contents
