Table of Contents
Advertisement
11
Mounting Cables
1568911, Edition 2019-04, Version 0
11.6 Connecting earthing cables to the extension arm with motor
arm Dual arm, with Navigator M6
(See "Figure 33")
The earthing cables are pre-assembled in the extension arm and the motor arm and must
be laid and connected in the direction of the arrow.
1. Observe the safety instructions in Chapter 11.1 on Page 46.
2. Lay and connect the earthing cables in the direction of the arrow illustrated in the
Figure, and then route them towards the interface plate if required.
3. Route the earthing cables① out of the Navigator M6 through the motor arm and the
bow②.
4. Route the earthing cables① through the extension arm and towards the interface
plate.
5. Route the mounted earthing cable③ of the flange along the ceiling tube towards the
interface plate.
11.7 Routing the supply cables and hoses through the extension
arm with motor arm Dual arm, with Navigator M6
(See "Figure 34")
The power supply cables and gas hoses are pre-assembled in the Navigator M6.
Order-specific cables, including nurse call and phone cables, must be separately routed
through the pendant system.
Note - Swinging out the electronic unit
To facilitate the installation, swing out the electronic unit as described in Chapter 11.3 on
Page 47.
1. Observe the safety instructions in Chapter 11.1 on Page 46.
2. Route the power supply cables and gas hoses① through the motor arm and the
bow② :
•
Next, route the Navigator M6 without exerting tensile stress on the supply cables and
hoses①.
•
Make sure that the laid cables are not damaged or torn off.
3. Route the supply cables and hoses① through the extension arm and towards the in-
terface plate.
4. Route order-specific cables (nurse call, phone, etc.) through the pendant system.
5. Mount the Navigator M6 onto the pendant system as described in the Installation In-
structions of the Navigator M6.
52
EN
Advertisement
Table of Contents
