Adjusting The Swivel Stop On The Extension Arm And Motor Arm; Versions; Tool To Be Used - Nuvo Navigator Lift 150 Single Installation Instructions Manual

Table of Contents

Advertisement

15
Adjustments
Figure 60: Adjusting the swivel stop on the extension arm and
motor arm (from top to bottom: Navigator Lift
Lift
150 / 250, Navigator Lift
150,Navigator
250 with Navigator
XL)
22,5°
22,5°
22,5°
15,0°
22,5°
15.6 Adjusting the swivel stop on the extension arm
and motor arm
(See "Figure 60")
The swivel stops must be adjusted during installation independently of
the system and application. At least 1 swivel stop must be mounted in or-
der to prevent the supply cables being damaged or torn off. The swivel
stops must be adapted to the specific characteristics of the room during
installation.
With 1 ball stop installed, the swivel range is restricted to a maximum of
340 degrees. With 2 ball stops installed, the swivel range can be restrict-
ed further.
Electric shock hazard
In order to prevent the internal supply cables twisting off,
at least 1 ball stop must be mounted. This individual ball
stop serves as twist protection:
• To restrict the angle of rotation of the extension arm
and motor arm to 340 degrees, mount at least 1 ball
stop as described in Chapter 15.6.3 on Page 78.

15.6.1 Versions

(See "Figure 60")
Proceed as follows in order to adjust the swivel ranges:
Navigator Lift
150 on the extension arm and motor arm in gradua-
tions of 22.5 degrees.
Use 1 setscrew M16 and 2 ball stops Ø 12.7mm for each extension
arm and motor arm.
Navigator Lift
150 / 250 on the motor arm in graduations of 22.5
degrees.
Use 1 setscrew M16 and 1 ball stop Ø 12.7mm for each motor arm.
Navigator Lift
250 on the XL extension arm in graduations of 15.0
degrees and on the motor arm in graduations of 22.5 degrees.
For the extension arm use 1 setscrew M20 and 2 ball stops Ø
16mm.
For the motor arm use 1 setscrew M16 and 2 ball stops Ø 12.7mm.

15.6.2 Tool to be used

A magnetic pin is required in order to offset the ball stop. A telescopic
magnet pick-up tool set can be ordered from Nuvo.
77
WARNING
1568911, Edition 2019-04, Version 0
EN

Advertisement

Table of Contents
loading

Table of Contents