Nuvo Navigator Lift 150 Single Installation Instructions Manual page 55

11 Mounting Cables
Figure 35: Connecting the cables to the motor arm Single arm, with Navigator M6
Table 04: Cable assignment: motor arm Single arm, with Navigator M6
No. in From
Fig. 35
③ Main board
④ Main board
⑤ Motor
⑥ End switch
⑦ Navigator M6
⑨ Assembly connec-
tion ⑧
⑪ Assembly
connection⑬
⑫ Bearing point
⑭ Mains connection
To Designation
DC/DC converter Power board / DC converter Power ca-
ble
DC/DC converter Power board / DC converter cable
Main board Motor connecting cable
Main board End switch board
Assembly connec- Navigator M6 interface / Navigator M6
tion ⑧ socket cable
Main board Control cable
DC/DC converter Brake1/PCB 1-arm cable
Assembly -
connection⑬
Main board Mains cable
55
Length Remark
[mm]
- Pre-assembled
- Pre-assembled
- Integrated in the motor
Pre-assembled
- Integrated in the Navigator M6
- Pre-assembled
- Pre-assembled
- Integrated in the bearing unit
4000 -
1568911, Edition 2019-04, Version 0
EN