Intended Use; Environmental Conditions; Obligations Of The Operating Company; Obligations Of Personnel - Fronius Robacta TSS /i Operating Instructions Manual

Intended Use

The device is to be used exclusively for its intended purpose.
The device is intended exclusively for the cleaning of Fronius welding torches.
Utilization for any other purpose, or in any other manner, shall be deemed to be "not in
accordance with the intended purpose." The manufacturer accepts no liability for any
damage resulting from improper use.
Proper use also means
-
-
-
The device is designed for operation in industry and business. The manufacturer shall
not be liable for any damage resulting from use in a living area.
The manufacturer shall also not be liable for faulty or incorrect work results.
Environmental Operation or storage of the device outside the stipulated area will be deemed as not in
Conditions accordance with the intended purpose. The manufacturer is not responsible for any dam-
age resulting from improper use.
Temperature range of the ambient air:
-
-
Relative humidity:
-
-
Ambient air: free of dust, acids, corrosive gases or substances, etc.
Altitude above sea level: up to 2000 m (6500 ft.)
Obligations of the The operating company must only allow persons to work with the device if they
Operating Com- -
pany
-
-
The safety-conscious work of the personnel must be checked regularly.
Obligations of All persons who are assigned to work with the device must do the following before begin-
Personnel ning the work:
-
-
Before leaving the workplace, ensure that no personal injury or property damage can
occur in one's absence.
Particular hazard
Do not linger in the operating area of the robot.
areas
Always integrate the device into a higher-level safety system in a secured area.
Reading and adhering to all instructions in the Operating Instructions
Reading and adhering to all safety instructions and danger notices
Carrying out all the specified inspection and servicing work
During operation: 0°C to + 40°C (32°F to 104°F)
During transport and storage: -25°C to +55°C (-13°F to 131°F)
Up to 50% at 40°C (104°F)
Up to 90% at 20°C (68°F)
Are familiar with the basic occupational safety and accident prevention regulations
and are trained in handling the device
Have read and understood these Operating Instructions, especially the section
"Safety Rules," and have confirmed this with their signature
Are trained according to the requirements for the work results
Follow the basic regulations for occupational safety and accident prevention
Read these Operating Instructions, especially the section "Safety Rules," and con-
firm that they have understood and will follow them by signing
7